Neptronic SKE4 — How to Set the Drain Cycle Frequency

The External Analog control profile on the Neptronic SKE4, where the 0–10 V humidity signal comes from an external controller: wiring examples and high-limit settings. Narrated in Turkish.

The control panel of the Neptronic SKE4 electric steam humidifier and the basics of its user interface. Narrated in Turkish.

How the Internal Analog control profile works on the Neptronic SKE4 and where its settings sit in the control menu. Narrated in Turkish.

How to view the service hours and total run hours of the Neptronic SKE4 from the control panel. Narrated in Turkish.

How to reset the service hours on the Neptronic SKE4 after maintenance. Narrated in Turkish.

How to set the blowdown (partial drain) rate on the Neptronic SKE4. Narrated in Turkish.

Selecting an industrial dehumidifier is never just a single capacity figure. This episode covers eight criteria, from target relative humidity and dew point, moisture load and technology to reactivation energy, casing, automation and service, and a five-step decision process.

There are three main technologies for industrial dehumidification: desiccant rotor, condensing and pool units. This episode compares their operating principles, achievable dew points, strengths and limits, and shows how the target dew point and the ambient temperature drive the right choice.

Selecting an industrial dehumidifier starts with an accurate moisture load calculation. This episode walks through the seven moisture sources, a worked infiltration example and how the target dew point drives the choice of technology.